Table Of Contents - D-Link DCS-2530L Quick Install Manual

Step 1:
Rotate the baseplate counterclockwise and remove it.
Step 2:
Place the baseplate where you want to position the camera
and use a pencil to mark the holes. You can use the lower
holes for a removable installation, or the top holes for a
fixed one. Make sure that the arrow on the baseplate is
pointing up.
Step 3:
Depending on the material of the wall or ceiling, use proper
tools to drill holes 25mm deep with a 6mm drill bit where
you marked. If the wall is made out of concrete, drill the
holes first, then insert the plastic anchors to support the
screws.
Step 4:
Place the baseplate over the holes that are in the wall or
ceiling. Make sure to align the baseplate holes with the
holes in the wall or ceiling. Use the supplied screws to
attach the baseplate to the surface of the wall or ceiling.
Step 5:
Place the camera over the baseplate with the alignment tab
pointing left, then attach the camera by rotating it until the
alignment tab points up.
Step 6:
Adjust the angle and rotation of the camera as desired. You
can also rotate the camera on the baseplate about 45° to
the right or left.
Mount the Camera
5
1
2
3
4
5
6