Removing Bezel Blanks - HP EliteDesk 800 G3 TWR Maintenance And Service Manual

Removing bezel blanks

On some models, there may be bezel blanks covering the optical drive bays. You must remove the bezel blank
before installing an optical drive. To remove a bezel blank:
1. Prepare the computer for disassembly
2. Remove the access panel
3. Remove the front bezel
4. To remove a 5.25-inch optical drive bezel blank, press inward on the two tabs on the right side of the
blank (1), and then rotate the blank off the front bezel (2).
To remove a slim optical drive bezel blank, press inward on the tab on the right side of the blank (1), and
then rotate the blank away from the front bezel (2) and slide the left side of the blank out of the slot on
the front bezel (3).
(Preparation for disassembly on page
(Access panel on page
(Front bezel on page 21)
20)
19)
Removing bezel blanks 23