Gps Antenna - Kenwood DNX994S Instruction Manual

● General Motors cars (DNX994S)
1) Cut out accessory 6 to meet the shape of the
opening of the center console.
2) Attach accessory 6 to the unit.
Cut out to meet the shape
of the opening in the
vehicle.
● Toyota/Scion cars (DNX994S)
1) Cut out accessory 6 as illustrated.
Cutting line
2) Fold double-sided adhesive (accessory 7)
along the slit and attach it to accessory 6
cut-out against the center rib as illustrated.
Use 2 pieces of accessory 7 for 1 accessory
6 cut-out.
3) Attach accessory 6 cut-out to the unit.
7
Ñ

GPS antenna

GPS antenna is installed inside of the car. It
should be installed as horizontally as possible
to allow easy reception of the GPS satellite
signals.
6 To mount the GPS antenna inside your vehicle:
1) Clean your dashboard or other surface.
2) Remove the separator of the metal plate
(accessory =).
3) Press the metal plate (accessory =) down
firmly on your dashboard or other mounting
surface. You can bend the metal plate
(accessory =) to conform to a curved surface,
if necessary.
4) Remove the separator of the GPS antenna
(accessory -), and stick the antenna to the
metal plate (accessory =).
6
NOTE
• Depending on the type of car, reception of the
GPS satellite signals might not be possible with
an inside installation.
• Please install this GPS antenna in an area away
from any antennas that are used with CB radios or
satellite televisions.
• The GPS antenna should be installed at a position
that is spaced at least 12 inch (30 cm) from
cellular phone or other transmitting antennas.
Signals from the GPS satellite may be interfered
with by these types of communication.
• Painting the GPS antenna with (metallic) paint
may cause a drop in performance.
Connection/Installation
-
=
91
English