Troubleshooting Unit fails to start Cooling or heating is not sufficient Cooling is not sufficient The followings are not malfunction...
Page 11
Troubleshooting INDOOR UNIT TROUBLE SHOOTING LED flash times Wired of indoor PCB Contents of Malfunction Possible reasons controller display LED4 LED3...
Page 12
Accessories Accessories supplied with the indoor unit: Name of parts Quantity Note Shape...
Is The Unit Installed Correctly Installation place Electric work When you change your address or the installation place For inspection and maintenance...
Installation Procedure Indoor Unit NOTE All wiring of this installation must comply with NATIONAL, STATE AND LOCAL REGULATIONS WARNING BE SURE TO READ THESE INSTRUCTIONS CAREFULLY BEFORE BEGINNING INSTALLATION. FAILURE TO FOLLOW THESE INSTRUCTIONS COULD CAUSE SERIOUS INJURY OR DEATH, EQUIPMENT MALFUNCTION AND/OR PROPERTY DAMAGE.
Page 16
Installation Procedure Indoor Unit 1. Preparation for suspending the unit a.Size of hole at ceiling and position of hanging bolts b.Hanger bolts installation 2.Installation of indoor unit Note Adjusting to the levelness...
Page 17
Installation Procedure Drain Pipe Installing Drain Pipes For unit without water pump Improper piping Good piping...
Page 19
Installation Procedure Drain Pipe Drainage Test Procedures Installation Procedure Air Duct Installation work for air outlet ducts Note Connection of suction, exhaust ducts a.Fresh air inlet b.Exhaust (Make sure to use also the suction.)
Page 20
Installation Procedure Electrical wiring WARNING DANGER OF BODILY INJURY OR DEATH Precautions for electrical wiring Selection of size of power supply and interconnecting wires Wiring connection...