Safety Devices - Electrolux IC43316 Operating Handbook

01103040
0409
Notice Date

Safety devices

Feed safety device
The space between the feed safety fl ap and the drive bands is too small for you to enter your
fi ngers. The machine stops automatically as soon as the fl ap is pushed in.
Protection of motors
The motors have overload protection :
• by thermomagnetic circuit breakers and
• by the electrical selector (for movement).
Restarting the machine
After each stoppage of the machine, power cut, emergency stop, or activation of the feed
safety, it will then be possible to start again.
- in the case of a machine with a standard console, only after pressing the green button of
the panel.
Gas heating
The gas burner is ignited and the fl ame is controlled by an electronic box that provides inte-
gral safety, for example if the fl ue draft is poor or if the gas supply is cut off.
If you have a standard console, the orange lamp signals that the system has been set to
safe. If this lamp fl ashes this signals that the machine has overheated.
A pressure switch connected to the combustion products outlet turns off the machine's hea-
ting function should extraction problems arise.
Accessibility
All casings can be disassembled using a special tool.
Heating safety device
The control panel applies an initial safety level at the time the machine starts up.
A safety thermostat, which is independent of all electronic systems, limits the heating tem-
perature of the ironing cylinder in all circumstances (except in the case of a steam heating
machine).
4
4
Page
4. Safety
OPERATING
HANDBOOK