Suspension Rods - GE GTUP270EMWW Technical Service Manual

Tub Cover
Note: The tub cover can be replaced without
removing the tub.
To remove the tub cover:
1. Remove the cover assembly. (See
.)
Assembly
Note: In the following step, dampening straps are
not present on some 24-in. models.
2. Disconnect 4 dampening straps from the tub
cover by removing four 5/16-in. hex-head
screws.
Dampening Strap (1 of 4)
3. Unsnap the 8 tabs that latch onto the rim of the
outer tub.
4. Lift and remove the tub cover.
Tub Cover

Suspension Rods

To remove the tub suspension rods:
1. Remove the cover assembly. (See
Assembly
Note: In the following step, dampening straps are
Cover
not present on some 24-in. models.
2. Disconnect 4 dampening straps from the tub
cover by removing four 5/16-in. hex-head
screws. (See
3. Lift up on the tub and pull the suspension rod
out of the slot in the tub.
Tab (1 of 8)
– 44 –
.)
.)
Tub Cover
Suspension Rod
Slot
Cover