Philips PET727/94 Quick Start Manual

Philips Portable DVD Player PET727

Quick Start Guide

Charge the built-in battery
1
1 Switch the ON/OFF
2 Connect the supplied AC adaptor to the
DVD Player and to the AC outlet.
The red charge indicator turns on. It takes about 4 hours to fully
charge the battery.
When the battery is fully charged, the red charge indicator turns off.
Tip
– You can only charge the battery when the temperature is between 0°C
and 35°C.
– When headphones are connected to the DVD Player, the fully charged
battery lasts about 2.5 hours.
2

Install remote control battery

1 Open the battery compartment.
2 Insert 1 CR2025 battery with correct polarity (+/-) as indicated.
3 Close the battery compartment.
CR2025
1 2
OFF
slide selector to the position.
DC IN 12V
CR2025

Play discs

3
1 Lift the display panel.
socket on the
2 Switch the
compartment.
• (For the fi rst time) Remove the protective card.
3 Insert a disc with the printed side facing up.
4 Push the lid down to close the disc compartment.
4

Connect a TV

On the DVD Player,
1 Connect the black end of the supplied AV cable to the
socket.
On the TV,
1 Connect the white end to the left audio input socket and the red
end to the right audio input socket.
2 Connect the yellow end to the video input socket.
OPEN
slide selector to the right to open the disc
Disc starts to play automatically. If not, press
If a menu appears, select an item and then press
PET727_94_QSG_V2.0
OK or 2; .
OK
to start play.
AV OUT
TV
AUDIO IN
VIDEO IN