Download
Share
Print this page
Epson EPL-N4000 Hardware Setup Manual
  1. Manuals
  2. Brands
  3. Epson Manuals
  4. Printer
  5. EPL-N4000
  6. Hardware setup manual
Epson EPL-N4000 Hardware Setup Manual

Epson EPL-N4000 Hardware Setup Manual

Hide thumbs Also See for EPL-N4000:

Advertisement

Quick Links

Download this manual See also: Service Manual, Reference Manual

Advertisement

loading

Related Manuals for Epson EPL-N4000

Summary of Contents for Epson EPL-N4000

  • Page 2: Printer Parts

    Printer Parts power switch face-down tray cover A control panel paper guide front cover lower cassette 1 MP tray lower cassette 2 extention cover B Ethernet interface connector stopper Type-B interface connector parallel interface connector optional Duplex Unit connector optional Multibin Unit connector optional Large Capacity Paper Unit...

  • Page 3: Table Of Contents

    Contents 1 Installing the Large Capacity Paper Unit ... . . 1 2 Installing the Imaging Cartridge ....8 3 Loading Paper .
  • Page 4 EPSON is a registered trademark of SEIKO EPSON CORPORATION. General Notice: Other product names used herein are for identification purposes only and may be trademarks of their respective owners. EPSON disclaims any and all rights in those marks. Copyright © 1998 by SEIKO EPSON CORPORATION, Nagano, Japan.

  • Page 5: Installing The Large Capacity Paper Unit

    Installing the Large Capacity Paper Unit Install the Large Capacity Paper Unit when setting up the printer. Skip this section if you will not use this option. 1. Open and unpack the shipping carton. 2. Cut the tape that holds the cardboard inserts. cut here 3.
  • Page 6 4. Carefully lift the Large Capacity Paper Unit out of the box with two or more people, and place it near the printer. 5. Lock the casters at the bottom of the unit by pushing their levers down.
  • Page 7 6. At the back of the unit, push the cable into the slot. 7. Carefully lift the printer with two or more people. Caution: The printer weighs about 50 kg (110.2 lb); always lift it with two or more people. Grasp the printer at the locations indicated below.
  • Page 8 8. Align each of the printer’s corners with those of the unit, then lower the printer until it rests securely on the unit. 9. Make sure all corners of the printer fit firmly onto the unit.
  • Page 9 10. Pull out lower cassette 2 as far as it will go. Then, lift it up slightly, and completely remove it. 11. Pull out lower cassette 3. Take out and open the included package of metal fittings and screws.
  • Page 10 12. Attach the two metal fittings with the screws as shown below. Note that the shape of the two fittings are different. 13. Push cassette 3 back into the unit, then replace cassette 2. 14. Pull out cassette 4 and remove the protective materials inside.
  • Page 11 15. Pull out lower cassette 5 and remove the protective materials inside. Be sure to open the inside cover and remove the protective insert. 16. Plug the cable from the Large Capacity Paper Unit into the appropriate connector at the back of the printer.

  • Page 12: Installing The Imaging Cartridge

    Installing the Imaging Cartridge Caution: Do not turn the imaging cartridge upside down. Do not open the drum's protective cover and avoid exposing the imaging cartridge to room light any longer than necessary. Overexposing the cartridge may cause abnormally dark or light areas to appear on the printed page and reduce the life of the cartridge.
  • Page 13 2. Remove the attached sheet. 3. Open cover A by pulling the latch. latch 4. Open the cover on the front of the printer.
  • Page 14 5. Holding the grip and tab on the imaging cartridge, insert the cartridge into the printer until it is housed completely. Note: Make sure the tab is pushed down and flush with the imaging cartridge. Otherwise, you cannot close the front cover or cover A. 6.
  • Page 15 7. Release the front cover; it closes automatically. 8. Close cover A by pushing it up and into the printer. latch Caution: Never transport the printer with the imaging cartridge installed.

  • Page 16: Loading Paper

    Loading Paper This section includes instructions on loading paper in lower cassettes 1 and 2. Lower Cassette 1 Loading Orientation Paper Size Vertical A4, A5, Executive, Letter, Half-Letter Horizontal A3, Ledger, Legal, Government Legal Lower Cassette 2 Loading Orientation Paper Size Vertical A4, Executive, Letter Horizontal...
  • Page 17 1. Pull out the cassette you want to load. 2. While pulling up the vertical paper guide, slide it outward as far as it will go.
  • Page 18 3. While pushing down the lever on the horizontal paper guide, slide the guide outward as far as it will go. 4. Fan a stack of paper and tap it on a flat surface to even the edges. Insert the paper face up into the cassette, placing the corners of the paper on the arrow mark inside the cassette.
  • Page 19 5. Adjust the vertical and horizontal paper guides to match the size of your paper. Caution: Make sure to adjust the paper guides to the paper size you load; otherwise, the printer will not print properly. 6. Take out the card with paper sizes printed on it. Fold it appropriately and insert it into the cassette to show the paper size that you loaded.
  • Page 20 7. Push the cassette back into the printer.

  • Page 21: Attaching The Power Cord

    Attaching the Power Cord 1. Make sure the power switch on the top of the printer is turned off, as shown below. 2. Insert the power cord into the AC inlet at the back of the printer. Then plug the other end into a properly grounded outlet.

  • Page 22: Test Printing

    Test Printing 1. Make sure the imaging cartridge is installed. Turn on the printer. Several messages appear on the display as the printer performs internal tests. After about 60 seconds, the Ready message appears. Caution: Do not turn the printer off for about 60 seconds after turning on the printer.

  • Page 23: Connecting The Printer To A Computer

    Connecting the Printer to a Computer Though this printer is intended to be used on a network, you can use the parallel interface to connect the printer directly to a computer. Note: Your printer also has room for an optional interface connector. See “Optional interfaces”...

  • Page 24: After Setting Up The Hardware

    3. Secure the connector by pushing the two wire clips together until they lock in place on both sides of the connector. 4. Connect the other end of the cable to your computer, and fasten it as required. 5. Turn on the printer, then turn on your computer. After Setting Up the Hardware After completing the hardware setup, check the following items.
  • Page 25 EPSON OVERSEAS MARKETING LOCATIONS EPSON AMERICA, INC. EPSON UK LTD. 20770 Madrona Ave. Campus 100, Maylands Avenue, P.O. Box 2842 Hemel Hempstead, Herts, Torrance, CA 90509-2842 HP2 7TJ, U.K. Phone: (800) 922-8911 Phone: (+44) 01442 261144 Fax: (310) 782-5220 Fax: (+44) 01442 227227 EPSON DEUTSCHLAND GmbH EPSON FRANCE S.A.