Lighting The Grill; Lighting The Main Burners - GE JGGN24 Owner's Manual

Lighting the grill.

Check Flame
Burner
Burner Port
LEFT RIGHT
OFF OFF
HI HI
IGNITOR
8
Before Lighting the Grill
The grill must be assembled in
accordance with the Assembly
Instructions.
Check that your LP tank is full and
properly connected to the regulator.
Check that there are no gas leaks in
the gas supply system. See the Leak
Testing section.
Check that the venturi tubes are properly
located over the gas valve orifices.
Check that both Main Burner and Side
Burner ignition wires are connected.
Read carefully all instructions contained
on the rating plate.

Lighting the Main Burners

WARNING:
TO LIGHT WITH THE IGNITOR:
1. Make sure control knobs are set to
OFF and turn on the gas supply by
opening the LP tank valve.
2. Push and turn right control knob
to HI .
3. Push the ignitor button 3 or 4 times.
The burner should ignite within
4 seconds.
After the right burner is lit, push
and turn left control knob to HI .
Left burner will ignite automatically.
If the Main Burner Will Not Light
1. Turn control knobs to OFF .
Wait 5 minutes, then try again.
Shutting Down
1. Turn off the gas supply by closing
the LP tank valve.
2. Turn control knobs to OFF .
CAUTION:
after lighting. All the ports on the burner
should show a 1 " (2.5 cm) flame on HI
setting.
If any of the following symptoms occur,
there is probably a blockage in the
venturi tubes. Shut off gas at once and
clean the venturi tubes. See the Venturi
tubes section.
1. You smell gas.
2. If a flashback fire occurs.
3. Your grill heats unevenly.
4. The burners make popping noises.
Open lid before lighting.
TO LIGHT WITH A MATCH:
1. Make sure control knobs are set to
OFF and turn on the gas supply by
opening the LP tank valve.
2. Insert lighted match through lighting
hole located at the bottom right of the
grill housing.
3. Push and turn right control knob to
HI . The burner should ignite within
4 seconds.
After the right burner is lit, push
and turn left control knob to HI .
Left burner will ignite automatically.
2. If any burner will not light, consult
the Troubleshooting Tips section at
the back of this manual. If problem
cannot be resolved, do not attempt
to operate the grill. Contact a
GE Authorized Service Center.
Check your grill