Ordering - GE T35 UR Series Instruction Manual

2.1 INTRODUCTION
2
Table 2–2: OTHER DEVICE FUNCTIONS
FUNCTION
Breaker Arcing Current I
Breaker Control
Contact Inputs (up to 96)
Contact Outputs (up to 64)
Control Pushbuttons
CT Failure Detector
CyberSentry™ security
Data Logger
Digital Counters (8)
Direct Inputs/Outputs (32)
Disconnect Switches
DNP 3.0 or IEC 60870-5-104 Protocol
a) OVERVIEW
The T35 is available as a 19-inch rack horizontal mount or reduced-size (¾) vertical unit and consists of the following mod-
ules: power supply, CPU, CT/VT, contact input and output, transducer input and output, and inter-relay communications.
Each of these modules can be supplied in a number of configurations specified at the time of ordering. The information
required to completely specify the relay is provided in the following tables (see chapter 3 for full details of relay modules).
2-2
Figure 2–1: SINGLE LINE DIAGRAM
FUNCTION
2
t Ethernet Global Data Protocol (optional)
Event Recorder
FlexElements (16)
FlexLogic Equations
IEC 61850 Communications (optional)
Metering: Current, Voltage, Power,
Modbus Communications
Modbus User Map
Non-Volatile Latches
Non-Volatile Selector Switch
Oscillography
Setting Groups (6)
T35 Transformer Protection System
Power Factor, Frequency
2 PRODUCT DESCRIPTION
FUNCTION
Time synchronization over IRIG-B or IEEE
1588
Time Synchronization over SNTP
Transducer Inputs/Outputs
Trip Bus
User Definable Displays
User-Programmable Fault Reports
User Programmable LEDs
User Programmable Pushbuttons
User Programmable Self-Tests
Virtual Inputs (64)
Virtual Outputs (96)

2.1.2 ORDERING

GE Multilin