Lamp; Lamp Replacement - Philips 2 Series User Manual

9. Maintenance

Lamp

When operation time
reaches the last 100 hours
of the average lamplife, the
message 'Warning: lamplife
has almost expired' will be
displayed on the screen,
each time the projector is
switched on. The lamp
indicator lights up orange.
The lamplife remaining can
be checked using the OSD
menu.
1. Press the Menu.
– The menu bar appears
on the screen.
2. Use Cursor Control to
move the cursor to
Settings.
3. Use Cursor Control to
select Lamp counter.
– The remaining lamplife
hours are displayed in
the action window at the
bottom of the screen.
– When the lamplife has
expired,the lamp
indicator lights up red
and the message
'Warning: lamplife has
expired' is displayed on
the screen.

Lamp Replacement

– For cooling purposes the lamp is open. When removing the
lamp do not tilt. If the inner tube is broken glass particles may
fall out.
– Be very careful. The lamp and lampholder may still be too hot
to touch.
– Keep lamp holder opening to your right. Do not touch lamp or
point lamp holder opening at anyone.
– A high-pressure lamp may break if handled improperly.
1. Press the Stand by button to switch off the projector.
– The standby indicator lights up red.
2. Wait 5 minutes for the lamp to cool down and the cooling fan
to stop and disconnect the mains lead and all other cables.
3. Turn the projector over. Never place the projector on the side
where the connections are located!
4. Unscrew the screws at the bottom of the cover and remove
the cover.
5. Read the caution and warning labels on the lamp cover.
6. Unscrew the lamp holder.
21
Caution!