LG ACC98WK User Manual page 6

UW93_event_080102 1/4/08 12:01 PM
Attaching the speakers to the Wireless
Receiver
a a
Connect the power cord of the Wireless
Receiver to the outlet.
b b
Connect the wires to the Wireless
Receiver.
Connect the Wireless Receiver and the rear
speaker (right, left) with the speaker cable.
Be careful of the following
• Set the distance between this unit and Wireless Receiver within 10m.
• Optimum performance can be implemented only when the Wireless
Transmitter and the Wireless Receiver within distance of 2m to 10m is used
since communication failure may occur if longer distance is used.
• Be sure to match the speaker cable to the appropriate terminal on the com-
ponents: + to + and – to –. If the cables are reversed, the sound will be dis-
torted and will lack base.
• It takes a few seconds (and may take longer) for the Wireless Transmitter and
Wireless Receiver to communicate with each other.
• When the unit is turned off, the Wireless Transmitter is in standby mode (off)
automatically after about 10 minutes.
• If the Wireless Transmitter is turned off, the Wireless Receiver will not func-
tion.
6
Page 6
About Ferrite Core
Be sure to attach the ferrite core to the speaker cables (for connecting to
this unit).
This ferrite core can reduce noises.
How to attach the ferrite core
1 Press the stopper [a] of the ferrite core to open.
2 Wind the cable once on the ferrite core. Attach the ferrite core near the
3 Close the ferrite core unitl it clicks.
unit (Refer to the fig.3 and comment.).
The length
here is as
(fig.3)
short as
possible.