Troubleshooting - Philips AZ 1025 Owner's Manual

TROUBLESHOOTING

If a fault occurs, first check the points listed below before taking the set for repair. If you are unable
to remedy a problem by following these hints, consult your dealer or service center.
WARNING:
Do not open the set as there is a risk of electric shock! Under no
circumstances should you try to repair the set yourself, as this would
invalidate the warranty.
PROBLEM
– POSSIBLE CAUSE
• REMEDY
No sound/power
– VOLUME is not adjusted
• Adjust the VOLUME
– Headphones are connected
• Disconnect headphones
– Power cord not securely connected
• Connect the AC power cord properly
– Batteries exhausted/incorrectly inserted
• Insert fresh batteries/ batteries correctly
– Batteries loaded but power cord still plugged
in and connected
• Detach the power plug from the MAINS jack
and the set
Poor radio reception
– Weak radio signal
• FM: extend and aim the telescopic antenna
for best reception;
• AM: rotate the set
CD playback does not work
– CD is badly scratched or dirty
• Replace or clean the CD, see Maintenance
– Laser lens steamed up
• Wait until lens has acclimatized
Environmental information
We have reduced the packaging to the minimum and made it easy to separate into three materials:
cardboard (box), expandable polystyrene (buffer), and plastic (bags, protective foam).
Your set consists of materials which can be recycled if disassembled by a specialized
company. Please observe the local regulations regarding the disposal of packing
materials, exhausted batteries and old equipment.
16
The type plate is located on the bottom of the set.
The CD skips tracks
– CD is damaged or dirty
• Replace or clean the CD
– SHUFFLE or PROGRAM is active
• Quit SHUFFLE/PROGRAM mode(s)
Poor cassette sound quality
– Dust and dirt on the heads, etc
• Clean deck parts etc., see maintenance
– Use of incompatible cassette types (METAL
or CHROME)
• Only use NORMAL (IEC I) for recording
Recording does not work
– Cassette tab(s) may be broken out
• Apply a piece of adhesive tape over the
missing tab space
Remote control does not function properly
– Batteries exhausted/incorrectly inserted
• Insert fresh batteries/ batteries correctly
– Distance between the set too large
• Reduce the distance