Advertisement
4
2
---26
5
ENGLISH
-
Z3 7
1. Mounting foot
2. Locking wedge
3. Computer eye
4. Battery compartment cover
5. Connection for synchronisation cable
6. Rotating reflector control
7. Rotating light beam control (wide anqle-normal-tele)
8. Coldur filter compartment
9. Aperture scale
10. ASA scale
11. ASA sliding control
12. Distance scale
13. Wide angle" normaHele sliding control (W"N-T)
14. Off/standby/load switch
15. Manual/automatic selector (M/A)
16. Power ratio/computer setting selector
17. Load indicator (load)
18. Button for test flash (test button)
19. Flash Range Check
20. Load indicator 1/2 guide number
21. Load indicator 3/4 guide number
22. Load indicator full guide number
23. Connection for power pack accessory
24. Subflash
25. Subflash on/off switch
26. Synchronisation cable
INSERTING THE BATTERIES
Remove the battery compartment cover 4 and insert four AA size batteries (prefer
ably the alkaline type) or rechargeable (nickel cadmium) batteries in the battery com"
partment.
Note: The batteries must be inserted with their polarity as indicated within the battery
compartment. Incorrect insertion will prevent proper operation of the flash unit.
Replace the battery compartment cover.
TESTING
To make sure that your flash unit is working properly and that the batteries are not run
down, set switch 14 to the standby position, press the switch and wait till lamp 20
lights up. Then press test button 18.
Advertisement
