Advertisement
IV
After each cycle
IMPORTANT: Allow the unit to cool for at least two minutes
before removing the sterilizer from the microwave.
1. Removing the sterilizer from the microwave: After
the unit has cooled, remove it from the microwave
by holding the skirt and/or safety grips and then
place on an even, heat-resistant surface.
NOTE: Items will remain sterile in the Express II Microwave Steam
Sterilizer for up to 24 hours providing the lid is not removed.
2. After removing the sterilizer from the microwave:
Remove the lid by unlocking the clips – When removing
the lid, point it away from you to allow steam to escape.
Care and cleaning
• Always drain the excess water from the unit and
rinse to prevent the build up of limescale.
• Always store when completely dry.
• The Express II Microwave Steam Sterilizer is
dishwasher safe.
E
Loading one VIA Feeding System and up to four
6oz/180ml OR 8oz/240ml VIA Cups and Lids*
1. Position the nipple in an outer nipple cavity.
2. Place the screw ring over the nipple.
3. Position the VIA Cups upside down around
the dome cap stem.
4. Place the VIA Adaptor on its side around the
racks edge (as shown).
5. Position the VIA Lids vertically around the racks
edge. Rims should face out for easier loading.
6. Place the dome cap in the unobstructed upper
slot of the dome cap stem.
F
To load the AVENT Tempo Natural Feeding Nurser
1. Open the inner locking ring of the screw ring and place
the screw ring in the basket with the locking tab facing
downwards. Ensure that the parts of the screw ring
that are in contact with the nipple are facing upwards.
2. Place the nipple and the dome cap in the basket as
you would when sterilizing a bottle assembly.
3. Follow sterilizing instructions.
Loading other feeding and baby product items
When sterilizing other NON-ELECTRICAL Philips AVENT
PRODUCTS simply place the components in the rack allowing
enough space so that steam can effectively circulate.
* Consists of VIA Cup, Lid and Adaptor, an Extra Soft Slow Flow Nipple, Dome Cap and Screw Ring
WARNINGS –
FAILURE TO FOLLOW INSTRUCTIONS MAY CAUSE
SCALDING OR DAMAGE TO THIS PRODUCT AND/OR
YOUR MICROWAVE
•
Always ensure you use 200ml of water before
sterilizing. (The unit should be emptied of
residual water before each subsequent use.)
•
Always follow loading instructions and
do not overload.
•
Do not use bleach or chemical sterilizing solutions/
tablets in sterilizer or on products to be sterilized.
•
Do not sterilize metallic or electronic items
in the sterilizer.
•
Do not microwave bottle brush.
•
Always use the appropriate heating time for the
power of your microwave unit. (see Table
•
In combination ovens, ensure grill is switched
off and has cooled before use.
•
Be sure that the lid is properly fastened to the
base before placing in microwave.
•
Always allow at least 2 minutes cooling time
before removing from the microwave.
•
Do not remove the lid from the sterilizer
immediately after cycle. Allow to cool as the
steam will be hot.
•
When removing from microwave, be sure to
hold the sterilizer level to avoid leaking or
spilling of hot water.
•
When taking the sterilizer out of the microwave,
BE CAREFUL – it will still be hot.
•
When removing the lid, point it away from you
to allow steam to escape.
•
Be careful when handling the sterilized
products as they may be hot.
•
Always keep out of reach of children.
NOTE: Do not overload the sterilizer.
NOTE: Do not place dome caps in the sterilizer upside down.
NOTE: The Express II Microwave Steam Sterilizer is designed
to specifically hold the wide shape of Airflex Natural
Feeding Bottles.
Some products featured may not be available in all
countries. Please contact Philips AVENT to check availability.
Philips AVENT is here to help
1.800.54.AVENT
www.philips.com/AVENT
In US manufactured for Philips Consumer
Lifestyle, a division of Philips Electronics North
America Corporation. 1600 Summer Street,
5 Fl., Stamford, CT 06905-5125
In Canada imported for Philips Electronics Ltd,
281 Hillmount Road, Markham, ON L6C2S3
EN
)
III
9
Advertisement
