Optical Drive; Pci Card; Lan Controller; Fibre Channel / Sas Controller - NEC Express5800 Configuration Manual

CONFIGURATION GUIDE
Notes for BTO with SSD
The smallest capacity HDD/SSD among ordered disks is installed in the 1st HDD bay (as system disk) at factory.

When the memory size is 64GB or more, system disk capacity should be at least 300GB. In that case, BTO with SSD is not
possible. If you want to use 200GB SSD as data disk in such a system, order the 200GB SSD separately and install it later.
Configuration of Dynamic disk
A disk installed OS must not be configured as Dynamic disk. Please use as Basic disk. A disk not installed OS (means a disk saved
user data) can support Dynamic disk.

If a mirrored volume (RAID-1) or RAID-5 volume is built on a dynamic disk, the System FT LED and Safe To Pull LED indicating
the status of the ft server may not be displayed correctly, and information of duplex and simplex status of the PCI module may
not be output to the event log properly. If you are going to use a dynamic disk, convert only a data disk to a dynamic disk and
build as a simple volume, spanned volume, or striped volume.

5 Optical Drive

Available bays: 1
Product Name / Description
Internal DVD Super Multi Drive
1 x DVD Super Multi drive, not including writing software

6 PCI Card

6.1

LAN Controller

Category
LAN Controller
NOTE:

Be sure to use NIC teaming feature (LBFO) supported by Windows Operating system.

For iSCSI (data) connection, NEC Storage M11e, M110, M310 are supported. For NEC Storage, contact your sales
representative or refer to the NEC Storage WEB site. (http://www.nec.com/global/prod/storage/)
6.2

Fibre Channel / SAS Controller

Category
Fibre Channel Controller
SAS Controller
NOTE:

For supported NEC Storage products to connect with N8803-040F, contact your sales representative or refer to the NEC
Storage WEB site. (http://www.nec.com/global/prod/storage/)
NEC Corporation
–
NEC Express5800/R320f / Windows model
Product Name / Description
1000BASE-T 2ch board kit : 2 x GbE NIC
Intel® Ethernet Server Adapter I350-T2V2
10GBASE-T 1ch Adapter Kit : 2 x 10GbE NIC
Intel® X540-T1
NOTE:
- p to one controller per module
U
- FCoE functionality is not supported
Product Name / Description
Fibre Channel 1ch Adapter Kit : 2 x FC Controller
QLogic QLE2670 16Gbps Fibre Channel Adapters
SAS Controller : 1 x SAS Controller
LSILogic SAS9300-8e 12Gbps Host Bus Adapter
NOTE:
- K410-322(02) SAS Cable is required for tape drive connection
Revision 1.0, August 2017
Part Number
(Standard)
Part Number
N8804-012
N8804-011
Part Number
N8803-040AF
N8803-041
12