Sharp CD-JX20X(GY) Service Manual page 10

Caution on Disassembly
Follow the below-mentioned notes when disassembling ths
unit and reassemblmg it, to keep its safety and excellent per-
formance:
1. Take cassette tape and compact disc out of the unit.
2. Be sure to remove the power supply plug from the wall
outlet before starting to disassemble the unit.
3. Take off nylon bands or wire holders where they need
be removed when disassembling the unit. After servicing
the unit, be sure to rearrange the leads where they were
before disassembling.
4. Take sufficient care on static electricity of integrated cir-
cuits and other circuits when servicing.
REMOVAL PROCEDURE FIGURE
Front panel ' 1
2. Screw
3. Open the cassette lid.
4. Socket
CD block screw
2. Socket
I. CD Screw
2. Socket
3. Flexible PWB (C3)xl
2. CD mechanism 1. Screw..
Frame (with PWB) 1. Screw
2. Socket
1. Screw
4 Tape mechanism
2. Socket
LCD PWB
1. Screw
2. Socket
3 Connector
6 CD switch PWB 1. Knob..
Removing the CD mechanism
Following the disassembling procedure, steps 1 and 2, remove
the CD mechanism.
Removing the frame (with main/CD switch/function
selection/volume/relay PWB)
Following the disassembling procedure, steps 1, 2, 3, remove
the frame.
Removing the tape mechanism
Following the disassembling procedure, steps 1 and 4, remove
the tape mechanism. However this procedure makes it difficult
wire treatment when assembling. Thera' fore disassemble, fol-
lowing the steps 1, 2, 3, 4, (As for removal of main parts refer
to P.16 - 17)
15-l
14.2
14-4
Figure
13-1
Figure 13-2
Black
Figure 14-l
CD mechanism
CD ~erw PWB
Figure 14-2
Figure 14-3
Figure 14-4
Figure 14-5