Problems Using The Recharging Dock - Philips intelligent remote control User Manual

THE CONFIGURATION FILE IS CORRUPTED
• The remote control has a configuration file that stores all of your custom
devices, commands, and macros. In the extremely unlikely event that this
configuration file gets damaged, the remote control displays a message asking
you to revert to the original configuration. If you see this message, you must
revert in order to continue using the remote control. All your custom devices,
commands, and macros will be lost, so you will need to reprogram the remote
control.
THE REMOTE CONTROL ERROR MESSAGES
The following error messages indicate a problem with the configuration file
where your custom commands are stored. Contact your dealer or Philips
customer service if one of the following messages appears on the display:
• Can't open configuration file
• Configuration file error
• No configuration file found
• Invalid configuration file version

Problems using the recharging dock

THE BATTERIES WON'T RECHARGE
• Make sure you're using the special battery pack that comes with the
recharging dock. Ordinary AA batteries can't be recharged using the dock.
THE INDICATOR LIGHT FLASHES
• Make sure the contacts on the charger and on the back of the remote control
are clean (see picture on page 14) and there are no obstructions between
them.
• Make sure the remote control is properly seated on the dock.
• Confirm that the rechargeable battery pack is installed properly in the remote
control.
IMPORTANT
recharging dock, remove it.
If the remote control becomes very hot while resting on the
Problems using the recharging dock 69