6. Fasten the mounting base onto
the dashboard with the tapping
screws.
Tapping screws
(3 × 12 mm)
CAUTION
• Before drilling any mounting
holes, confirm that the screws
will not interfere with any of the
vehicle's operating systems (such
as the fuel line, brake lines, elec-
trical wiring, etc.).
Dashboard
7. Adjust the display vertical posi-
tion and display angle.
In order to stabilize the display, adjust
the display vertical position so that the
bottom of the display base contacts the
dashboard. Adjust the display to a
good angle for viewing.
If you loosen the hidden screw
with the supplied hexagonal
wrench, you can adjust the
vertical position of the display.
(Refer to the step 3
on page 34.)
Dashboard
If you turn this knob to the left, you
can adjust the angle of the display.
Note:
• After you have adjusted the display vertical
position and angle, turn the hidden screw and
the knob clockwise to fasten the display in
place.
36