Upon Delivery Inspection Procedures; Inverter Type Designation; Chapter 2 - Inspection Procedure, Component Identification And Standard Specification - GE AV-300I User Manual

Chapter 2 - Inspection Procedure, Component Identification and

2.1. Upon Delivery Inspection Procedures

2.1.1. General
A high degree of care is taken in packing the AV-300i Drives and preparing them for delivery. They should only
be transported with suitable transport equipment (see weight data). Observe the instructions printed on the
packaging. This also applies when the device is unpacked and installed in the control cabinet.
Upon delivery, check the following:
- the packaging for any external damage
- whether the delivery note matches your order.
Open the packaging with suitable tools. Check whether:
- any parts were damaged during transport
- the device type corresponds to your order
In the event of any damage or of an incomplete or incorrect delivery please notify the responsible sales offfices
immediately.
The devices should only be stored in dry rooms within the specified temperature ranges .
N !
OTE
A certain degree of moisture condensation is permissible if this arises from changes in
temperature (see section 2.4.1, "Permissible Environmental Conditions"). This does not,
however, apply when the devices are in operation. Always ensure that there is no moisture
condensation in devices that are connected to the power supply!

2.1.2. Inverter Type Designation

The technical specification of the AV-300i Drive is stated in the type code. Example:
Drive rating in Horsepower with 150% overload for 60s (1)
GEH-6668A AV300i User's Guide
Standard Specification
Figure 2.1.2.1: Inverter type designation
GE Industrial Control Product
AV-300i product
Input voltage (5=575 VAC)
Phases for input voltage (3= 3 phase)
Drive Options (2)
Enclosure type (1=IP20)
Major revision level
Minor revision level
Chapter 2 - Inspection Procedure, ..., Standard Specification • 19
6K AVI 5 3 002 N 1 A 1