Table of Contents
Advertisement
Troubleshooting
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
Before You Call for Service
If Service
is Required
Ifthe unit ap_ars
to be malfunctioning,
Contact the dealer where you purchased
the
read through this manual first. Ifthe problem
unit if service is required. State the model
persists, check the Troubleshooting Guide
below. Locate the problem inthe guide and
referto the cause and its remedy before calling
for service. The problem may be something
very simple that can be solved without a
service call.Consulting or contracting a
qualified service technician may be necessary.
and serial number and explain the problem.
The model and serial number plate is located
on the ceiling of your unit, Ifyou do not know
the name of the selling dealer or a local
service company, you can check online at
www.electroluxappliances.com
or call
1- 77-435-32 7
Unit not cold
enough.
Adjust
temperatures
(see "Adjusting
the Temperature"
in the "Start-Up
and Temperature
Control" section).
Unit too cold.
Contents of unit
too cold/frozen.
Adjust temperatures
(see "Adjusting
the Temperature"
in the "Start-Up
and Temperature
•
Control set toowarm.
Light staying on.
Airflow to front grille
blocked.
Drawer gasket not
sealing properly.
Control set too cold.
Drawer gasket not
sealing properly.
i!i!i!_!_!_i_ii_i_i_i_ii_ii_i_ii_i_!_!i!ii!ii!ii!iiiiiiiii_
Adjust temperature colder, Allow 24
hours for temperature to stabilize.
Turn off manual light control.
See "Operation"
section.
Airflow must not be
obstructed to front grille. See
"Installation"
section.
Adjust drawer gasket.
Adjust temperature warmer.
Allow 24 hours for temperature
to stabilize.
Control" section).
No interior light.
•
Failed LED assembly.
•
Contact a qualified Electrolux
Service Technician.
Light will not go
•
Manual light control
•
Turn off manual light control.
out when drawer is
is ON.
See "Operation" section.
closed.
•
Drawer switch not
•
Check for proper drawer
making contact,
alignment.
Alarm(s) will not
•
Drawer is ajar.
•
Press "Power" key to
shut off.
acknowledge alarm.
Power has failed.
•
Ensure drawer is closed firmly.
Internal temperature is
•
Allow 24 hours for temperature
too high.
to stabilize.
Power is not
•
Circuit breaker has
•
Verify electrical supply. See
restored after
tripped.
"Installation" section.
_ower failure.
Advertisement
Table of Contents
