Setting The Balance - Pioneer PDR-W839 Operating Instructions Manual

5 Recording Features
TIME
MENU/
DELETE
1
ENTER
CHECK
1 Prepare for recording
must be pressed before going to step 2. See
REC MODE
pages 20–23 for step-by-step recording instructions.
2 Press CHECK to start the CD playing.
The track/disc to be recorded starts playing and the
indicator starts blinking.
3 Press the REC VOL. knob to adjust
the current recording level.
You see the current setting. If the
means the fixed setting is on, and you cannot change the
level. Press the
REC VOL
Use the level meter to gauge the best recording level (the
loudest sounds in the source should reach no higher than
the 0dB mark on the meter; the red segments in the level
meter should not light at all.
To fix the recording level at your setting, press the
. knob again (the
VOL
recording level to zero, hold down the
three seconds.
4 When you're satisfied with the
recording level, press CHECK again.
30
En
COMPACT DISC RECORDER / MULTI-CD CHANGER
¡
indicator lights, it
FIX
. knob again to turn it off.
indicator lights).To reset the
FIX
. knob for
REC VOL
◊ÛB¿ˆ˘≤/
3
- COMPACT DISC MULTI CHANGER

Setting the balance

You can increase the relative volume of the right or left channel for
both recording and playback. However, It is generally not necessary
to change the balance of a commercially recorded source.
1 Make sure the recorder is stopped,
SCAN
then press REC MODE.
The recorder goes into record-pause.
2 Press MENU/DELETE.
3 Turn the jog dial until BALANCE
appears in the display, then press to
ENTER.
4 Adjust the balance using the jog dial
(1 and ¡).
You can adjust the balance from 0dB (default) to around
REC
-5dB in either direction.
• Pressing the jog dial (
resets to center position.
5 Press the jog dial (ENTER) to confirm
the balance.
COMPACT DISC DIGITAL RECORDER
MENU/
REC MODE
DELETE
¶
Legato Link Conversion
CD TEXT
) and holding for 3 seconds
ENTER
REC VOL
PUSH ENTER