Configuring A Port Group; Setting Speed Options For Auto Negotiation On An Ethernet Interface - HP 3600 v2 series Configuration Manual

Configuring a port group

Some interfaces on your switch might use the same set of settings. To configure these interfaces in bulk
rather than one by one, you can assign them to a port group.
You create port groups manually. All settings made for a port group apply to all the member ports of the
group.
Even though the settings are made on the port group, they are saved on each interface basis rather than
on a port group basis. You can only view the settings in the view of each interface by using the display
current-configuration or display this command.
Follow these steps to configure a manual port group:
To do...
Enter system view
Create a manual port group and
enter manual port group view
Assign Ethernet interfaces to the
manual port group
Configure jumbo frame support
Enable auto power-down
Setting speed options for auto negotiation on an Ethernet
interface
Speed auto negotiation enables an Ethernet interface to negotiate with its peer for the highest speed that
both ends support by default. You can narrow down the speed option list for negotiation.
Use the command...
system-view
port-group manual
port-group-name
group-member
interface-list
jumboframe enable
[ value ]
port auto-power-down
8
Remarks
—
Required
Required
If you use the group-member interface-type
interface-start-number to interface-type
interface-end-number command to add multiple
ports in batch to the specified port group, make
sure that the interface-end-number argument
must be greater than the interface-start-number
argument.
Required
By default, the switch allows jumbo frames
within 10000 bytes to pass through Ethernet
interfaces.
If you set the value argument multiple times, the
latest configuration takes effect.
Required
Disabled by default.