Pioneer DV-563A Operating Instructions Manual page 57

Initial Settings menu
• Default setting: Interlace
Initial Settings
Digital Audio Out
TV Screen
Video Output
Component Out
Language
S-Video Out
Display
Options
Speakers
If you have a progressive-scan compatible TV,
set this to Progressive for flicker-free video
output. If your TV is not compatible with
progressive-scan video, set to Interlace.
Check the operating instructions that came
with your TV if you're unsure about its
compatibility.
• When setting to Progressive, you have to
press ENTER once more to confirm. See
also below for important information on
progressive scan video.
About progressive scan video
Compared to interlace video, progressive
scan video effectively doubles the scanning
rate of the picture, resulting in a very stable,
flicker-free image. Progressive scan video is
available only from the component video
output.
• Taiwan model and when TV system is set
to AUTO or NTSC only: When Compo-
nent Out (see above) is set to Progres-
sive, there is no video output from the
VIDEO OUT (composite) and S (S-video)
jacks. If you want to display video on more
than one monitor simultaneously, make
sure that it is set to Interlace. See also
Setting the TV System on page 81.
• If you connect a TV that is not compatible
with a progressive scan signal and switch
the player to progressive, you will not be
able to see any picture at all. In this case,
switch everything off and reconnect using
Progressive
Interlace
• Taiwan model and when TV system is set
• When TV System is set to PAL only:
the supplied video cable (see Easy
connections on page 14), then switch
back to Interlace. Switch the player to
standby then, using the front panel
controls, press STANDBY/ON while
pressing to switch the player
back to Interlace.
STANDBY/ON
FL DIMMER
STANDBY/ON
to AUTO or NTSC only: When set to
Progressive, PAL and NTSC discs are
both output as progressive NTSC video.
See page 81.
Progressive video is not output. See
page 81.
09
57
En