JVC NX-F3B Service Manual page 13

3.1.5 Removing the Micon board (See Fig.14 to15)
(1) Disconnect the connector wire from Fan connected to con-
nector CN461 of the Micon board. (See Fig.14)
(2) Disconnect the card wire from SCART board connected to
connector CN601 of the Micon board. (See Fig.14)
(3) Disconnect the card wires from Front end board connected
to connectors CN701,
board. (See Fig.14)
(4) Disconnect the connector wire from Front end board con-
nected to connector
Fig.14)
(5) Disconnect the card wire from Tuner pack connected to
connector CN421 of the Micon board. (See Fig.14)
(6) Disconnect the card wire from Loader board connected to
connector CN451 of the Micon board (See Fig.14)
(7) Disconnect the connector wire from power board connect-
ed to connector CN981
(8) Disconnect the card wire from USB jack board connected
to connector CN203 of the Micon board. (See Fig.14)
(9) Remove the four screws L attaching the Micon board. (See
Fig.15)
3.1.6 Removing the USB jack board (See Fig.16)
(1) Disconnect the connector wire from Front end board con-
nected to connector CN301
(2) Remove the one screw M attaching the USB jack board.
(3) Lift up the right side, and then slide to leftward and remove
the USB jack board.
CN481 and CN661 of the Micon
CN702 of the Micon board. (See
of the Micon board. (See Fig.14)
of the USB jack board.
CN702
CN421 CN601
CN451 CN701
CN661
Fig.14
L
Fig.15
CN301
Fig.16
CN461
CN981
CN203 CN481
L
M
(No.MB662<Rev.003>)1-13