Cover Presence Switch - Lenovo ThinkStation P510 Hardware Maintenance Manual

2. Pivot the optical-drive bracket inward as shown until it snaps into position.
Figure 54. Installing the optical-drive bracket
3. Reinstall the direct cooling air baffle. See "Direct cooling air baffle" on page 101.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 189.

Cover presence switch

Attention: Do not open your computer or attempt any repair before reading and understanding the Chapter
1 "Read this first: Important safety information" on page 1.
To replace the cover presence switch, do the following:
1. Prepare your computer. See "Preparing your computer and removing the computer cover" on page 99.
2. Remove the direct cooling air baffle. See "Direct cooling air baffle" on page 101.
3. Remove the optical-drive bracket. See "Optical-drive bracket" on page 122.
4. Locate the cover presence switch. See "Computer components" on page 33.
5. Disconnect the cover presence switch cable from the system board. See "Parts on the system board"
on page 35.
124
ThinkStation P510 and P710 Hardware Maintenance Manual