Use Of Detergent And Rinse Aid - Zanussi ZDS 201 User Manual

Use of detergent and rinse aid

1 2
30
20
7
Use of detergent
To help the environment, do not use more than the
correct quantity of detergent.
Obey the instructions on the detergent packaging.
How to fill the detergent dispenser:
1. Press the release button
detergent dispenser.
2. Put the detergent in the dispenser
3. If the washing programme has a prewash phase, put a
small quantity of detergent on the inner part of the ap-
pliance door.
4. If you use the detergent tablets, put the tablet in the
detergent dispenser
5. Close the detergent dispenser. Press the lid until it
locks into position.
Use long washing programmes when you use the
detergent tablets. These cannot fully dissolve with
short washing programmes and can decrease the washing
results.
Use of rinse aid
Rinse aid makes it possible to dry the dishes with-
out streaks and stains.
The rinse aid dispenser automatically adds rinse aid dur-
ing the last rinsing phase.
8
3 4
A
-
+
6
2 7
to open the lid
1
.
1
.
Do these steps to fill the rinse aid dispenser:
1. Press the release button
rinse aid dispenser.
2. Fill the rinse aid dispenser
mark 'max' shows the maximum level.
3. Remove the spilled rinse aid with an absorbent cloth
to prevent too much foam during the washing pro-
gramme.
4. Close the rinse aid dispenser. Press the lid until it
locks into position.
Adjust the rinse aid dosage
Factory set: position 3.
5 You can set the rinse aid dosage between position 1 (low-
est dosage) and position 4 (highest dosage).
Turn the rinse aid selector
dosage.
Using combi detergent tablets
These tablets contain agents as detergent, rinse aid and
dishwasher salt. Some types of tablets can contain other
agents.
of the
When you use tablets, that contain salt and rinse aid, do
not fill the salt container and rinse aid dispenser. The
rinse aid indicator stays on when the appliance is activa-
ted.
Be sure that these tablets are applicable for the water
hardness in your area (refer to the instructions on the
packaging of the products).
1. Adjust the water hardness to the lowest level. Refer to
'Setting the water softener'.
2. Set the rinse aid dosage to the lowest position.
Using again separately detergent, salt and rinse aid
1. Fill the salt container and the rinse aid dispenser.
2. Adjust the water hardness to the highest level.
3. Start a washing programme without dishes.
4. When the washing programme is completed, adjust
the water softener to the water hardness in your area.
5. Adjust the quantity of rinse aid.
6 5
to open the lid
3
with rinse aid. The
4
to increase or decrease the
of the