D-Link DGE-530T Quick Install Manual page 7

After you install your new D-Link adapter, by default, the TCP/IP
settings should be set to obtain an IP address from a DHCP server
(i.e router) automatically. To verify your IP address, please see the
following steps below.
Windows
cmd and click OK.
Windows
> Command Prompt.
At the prompt, type ipconfig and press Enter.
This will display the IP address, subnet mask, and the default gateway
of your adapter.
If the address is 0.0.0.0, check your adapter installation, security
settings, and the settings on your router. Some firewall software
programs may block a DHCP request on newly installed adapters.
6 7
Configure your Adapter
2000/2003/XP: Click on Start > Run. In the run box type
®
: Click on Start > All Programs > Accessories
7/Vista
® ®
Configure your Adapter
D-Link DGE-530T Quick Install Guide