D-Link DWL-520+ Quick Installation page 9

Making changes to the DWL-520+'s factory settings. By clicking on the
menu, changes can be made to the default wireless settings of the DWL-520+.
G. SSID: The Service Set
Identifier is the name
assigned to the wireless
network. The factory SSID
setting is set to default.
Make changes here to
match the SSID on
existing Wireless Router
or Access Point.
G
H
I
J
K
L
J. TxRate: You can adjust
the transmission rate to get
the best signal possible
depending on your usage
and your environment.
The preamble
setting of the
DWL-520+ must match the
preamble setting of the
Wireless Router or Access
Point in order to communicate
on the network.
I.
channel is set to 6. Channel
selection is automatically
determined by the DWL-520+
H. Wireless Mode:
depending on the channel setting
The factory setting is
of the access point selected for
set to Infrastructure.
association. To change the
Ad-Hoc mode is used
channel settings, the Wireless
for peer-to-peer
Mode must be set to Ad-hoc.
networking.
K. Preamble: By default,
D-Link AirPlus Products are
set to Long Preamble. The
Preamble defines the length
of the CRC block (Cyclic
Redundancy Check is a
common technique for
detecting data transmission
errors) for communication
between the Access Point
and wireless network
adapters. High network
traffic areas should use the
shorter preamble type.
Configuration
Channel: By default, the
By default the 4x
feature is enabled.
To disable the 4x
feature click 4x
Disable.
L. Power Mode: By
default, Power Mode is
set to Continuous
Access Mode.
Continuous Access
Mode — this default
setting consumes the
most power. Maximum
Power Save — this
setting consumes the
least power. Power
Save — this setting
consumes a moderate
amount of power.