Snmp - D-Link AC1200 User Manual

Section 3 - Configuration
SNMP (Simple Network Management Protocol) is a widely used network monitoring and control protocol that reports activity on each network device
to the administrator of the network. SNMP can be used to monitor traffic and statistics of the DWR-118. The DWR-118 supports SNMP v1 and v2c.
SNMP Local: Select whether to Enable or Disable local SNMP administration.
SNMP Remote: Select whether to Enable or Disable remote SNMP administration.
Get Community:
Enter a password in this field to allow read-only access to network
administration using SNMP. You can view the network, but no
configuration is possible with this setting.
Set Community:
Enter a password in this field to enable read/write access to the
network using SNMP.
IP 1/IP 2/IP 3/IP 4:
Enter up to 4 IP addresses to use as trap targets for your network.
SNMP Version:
Select the SNMP version of your system.
WAN Access IP
If you want to limit remote access SNMP access, enter the IP
Address
address of the remote computer you will use to access this device;
all other IP addresses will be denied remote SNMP access.
Click Apply to save your settings, or Refresh to revert to your
previous settings.
D-Link DWR-118 User Manual

SNMP

46