Hitachi CL 10D2 Technical Data And Service Manual page 28

(f) Mounting the assembly to the main body
(i) Insert the Ball Bearing 608VVC2PS2L [23] in the ball bearing chamber of Housing (A) [2] (Fig. 40).
(ii) Press-fit the Third Pinion [21] in the Second Gear [22] and insert it in the Ball Bearing 608VVC2PS2L [23] of
Housing (A) [2] (Fig. 40). At this time, apply grease (Nippeco SEP-3A) to the outer circumference of the
Second Gear [22].
(iii) Mount the Gear Cover [19] to the housing keeping Bracket (A) [42] at the maximum cutting position in the
same manner as the removal procedure (be careful of the spring force) (Fig. 41).
(iv) Tighten the four Tapping Screws (W/Flange) D5 x 25 (Black) [17] and the two Tapping Screws D5 x 35 [43]
(Fig. 41).
CAUTION: Check that there is no scratch, dust or chips on the surfaces of the cam and the roller.
(g) Reassembly of the Return Plate [41]
Align the Return Plate [41] with the Roller Pin [54] and Bolt (A) [39]. Insert the pin of the Cam Shaft [55] in
the hole of the Return Plate [41] and secure them with the two Seal Lock Screws (W/SP. Washer) M4 x 12
[40] (Fig. 41).
[21]
[22]
[23]
Fig. 40
--- 25 ---
[17]
[40]
[43]
[41]
Fig. 41
Maximum
cutting
position