RC-W305 Safety Precautions XL-SV320SL/SV305GD XL-SV308BU 1. This design of this product contains special hardware and many circuits and components specially for safety purposes. For continued protection, no changes should be made ti the original design unless authorised in writing by the manufacturer. Replacement parts must be identical to those used in the original circuits.
RC-W305 Preventing static electricity Electrostatic discharge (ESD), which occurs when static electricity stored in the body, fabric, etc. is discharged, can destroy the laser diode in the traverse unit (optical pcikup). Take care to prevent this when performing repairs. 1.1. Grounding to prevent damage by static electricity Static electricity in the work area can destroy the optical pickup in devicessuch.
RC-W305 Disassembly Method XL-SV320SL/SV305GD XL-SV308BU Remove the back cabinet 1, Open the battery cover and remove 2 screws inside it. (Screw A) Screw A 2, Remove 5 screws on back side. (Screw B) Screw B Then the unit would be disassembled.
RC-W305 Adjustment Method Instrument required Precautions for alignment 1 Direct connect to the IF sweeper output 1 Low frequency oscillator side and 1 UF and 22 Kohm connect to the This oscillator should have a capacity to output sweeper input side . Same as FIG1 .
Page 6
RC-W305 XL-SV320SL/SV305GD TUNER ADJUSTMENTS XL-SV308BU Use a plastic screw driver for adjustments. Adjust the intermediate frequency of AM and FM to the frequency of ceramic filter. Set of unit Supply voltage : DC 9.0V Speaker impedance :8 ohms Standard output...
Page 7
RC-W305 e. FM Adjustment Band switch : FM FM Dummy antenna : 75 ohms unbalance Adjusting Connection position of VTVM Step SG Frequency Adjustment Circuit Input Output tuning dial Oscilloscope Connect sweep Connect sweep generator to generator to IC101 10.7 MHz...