4. Remove the power connecting board as shown.
Figure 11. Removing the power connecting board
5. Record the cable routing and cable connections, and then disconnect all cables from the I/O board.
6. Remove the I/O board as shown.
Figure 12. Removing the I/O board
7. Install the new I/O board.
8. Route all the cables that you disconnected from the failing I/O board, and then connect the cables to
the new I/O board. See "Parts on the main boards" on page 20.
9. Reinstall the power connecting board.
10. Reinstall the I/O board shield. See "Replacing the I/O board shield" on page 26.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 47.
Replacing the discrete graphics card
Attention: Do not open your computer or attempt any repair before reading and understanding the Chapter
1 "Read this first: Important safety information" on page 1 .
To replace the discrete graphics card, do the following:
28
ideacentre 610S Hardware Maintenance Manual