JVC RM-RE9000 Service Manual page 5

Removing the modular jack board
assembly
1. Remove the rear cover.
2. Remove the remote controller transmission board
assembly.
3. Remove the main board assembly.
4. Remove the two screws I attaching the modular jack
board assembly.
5. Remove the connector CN501 connecting the main
board assembly to the connector terminal board
assembly.
Removing the switch board
1. Remove the rear cover.
2. Remove the remote controller transmission board
assembly.
3. Remove the main board assembly.
4. Remove the modular jack board assembly.
5. Remove the seven screws J attaching the switch
board.
6. Remove the board by lifting it.
Removing the top panel
1. Remove the rear cover.
2. Remove the remote controller transmission board
assembly.
3. Remove the main board assembly.
4. Remove the modular jack board assembly.
5. Remove the board.
6. Remove the two screws K attaching the lens and the
top panel.
Reminder when the top panel is
reassembled
1.
When the top panel is reassembled, use the screws
with the specified size (M3x8mm) without fail
(Screws marked K).
Using longer screws may damage the top panel and
cause the top panel unstable.
(See Fig.8)
Modular jack board
assembly
(See Fig.9)
J
J
(See Fig.10)
Lens
Top panel
CN501
Fig.8
Switch board
J
J
Fig.9
K
Fig.10
RM-RE9000
I
I
J
J
J
K
1-5