When checking the P.C.B.s:
•
Put the rubber sheet and the cloth over this unit, and
place the sub-chassis unit on them as shown below.
(Fig. 8)
•
Connect the ground points of the POWER (1) P.C.B.
(G2) to the chassis with a ground lead or the like.
(Fig. 8)
•
Reconnect all cables (connectors) that have been
disconnected.
•
When connecting the flexible flat cable, be careful
with polarity.
Ground lead
アース線
POWER (1) P.C.B.
Chassis
シャーシ
Cabinet L assembly
キャ ビネッ ト L Ass'y
AWCD2A P.C.B.
Rubber sheet and cloth
ゴムシー トと布
G2
Cabinet R assembly
キャ ビネッ ト R Ass'y
Rubber sheet and cloth
ゴムシー トと布
Fig. 8
YSP-CU4300/YSP-CU3300/NS-WSW160
P.C.B. をチェックする場合には:
・ 本機の上にゴムシートと布を敷き、その上に P.C.B. を
置きます。 (Fig. 8)
・ POWER(1)P.C.B. の G2 の ア ー ス を リ ー ド 線 等 で
シャーシに接続してください。 (Fig. 8)
・ 外したケーブル(コネクター)をすべて接続します。
・ フラットケーブルを接続する際、極性に注意してく
ださい。
DAMP P.C.B.
DGITAL P.C.B.
POWER (3) P.C.B.
INPUT (1) P.C.B.
POWER (2) P.C.B.
31