Installing A Surveillance Cabinet And Camera; Installing The Wall Mount; Attaching The Mounting Cap And The Camera - Bosch AUTODOME IP 5000i IR Installation Manual

AUTODOME IP 5000i IR
7

Installing a Surveillance Cabinet and Camera

The surveillance cabinet can attach directly to a wall, to a corner mount, or to a pole mount.
To install the cabinet (power supply box), follow the instructions in the Surveillance Cabinet
Installation Manual.
1.
Ensure that the cables are long enough to reach through the mount and the camera's
mounting cap to the connections from the camera.
7.1

Installing the Wall Mount

1.
2.
7.2

Attaching the Mounting Cap and the Camera

1.
2.
3.
4.
5.
6.
7.
Bosch Security Systems
Thread the cables through the wall and the mounts.
Slide the mounting flange over the wall mount.
Attach the wall mount to the mounting flange and fix them on the front door of the Wall-
mount Surveillance Cabinet by using four M5 screws.
To ensure a watertight seal, wrap Teflon tape four times around the threads at the end of
the wall mount.
Attach the mounting cap to the wall mount.
Thread all connection cables through the mounting cap.
Attach the hook at the end of the Safety Tether to the loop attached to the top of the
camera.
Connect the mating connectors on the user-supplied cables to the matching connectors
on the camera. Refer to the chapter Connection for more information.
2.
Place the top of the camera inside the mounting cap.
Rotate the camera approximately 15 degrees in a clockwise direction to lock firmly into
place.
Installing a Surveillance Cabinet and Camera | en
1.
Installation Manual
15
2017.08 | 1.0 |