Management Menu - Dell 1200MP Owner's Manual

SALE on Projector Bulbs at www.BulbAmerica.com

Management Menu

L AMP H OUR —Displays the operating hours since the last timer reset.
AMP ESET
L R —After you install a new lamp, select Yes to reset the lamp timer.
P OWER S AVING —Select Yes to set the power saving delay period. The delay period is
the amount of time you want the projector to wait without signal input. After that
set time, the projector enters power saving mode and turns off the lamp. The
projector turns back on when it detects an input signal or you press the Power
button. After two hours, the projector turns off and you need to press the Power
button to turn the projector on.
O L OCK —Select On to enable the OSD Lock for hiding the OSD menu. To
SD
display OSD menu, press the
on the remote control for 15 seconds.
UTO OURCE
A S —Select On (the default) to auto detect the available input signals.
When the projector is on and you press Source, it automatically finds the next
available input signal. Select Off to lock the current input signal. When Off is
selected and you press Source, you select which input signal you want to use.
CO ODE
E M —Select On to use the projector at a lower power level (150 Watts),
which may provide longer lamp life, quieter operating, and dimmer luminance
output on the screen. Select Off to operate at normal power level (200 Watts).
O T IMEOUT —Use this function to set the duration OSD menu stay active (at idle state).
SD
22
Using Your Projector
take additional 5% Off with coupon code 5PDF
M ENU
on the screen.
ROJECTION
P
•
•
reverses the image so you can project from behind
a translucent screen.
•
projector turns the image upside down for ceiling-
mounted projection.
•
projector reverses and turns the image upside
down. You can project from behind a translucent
screen with a ceiling-mounted projection.
IGNAL
S
(RGB, YCbCr, or YPbPr).
button on the control panel or the Menu button
L OCATION —Select the location of the OSD
ODE —Select how the image appears:
M
Front Projection-Desktop (the default).
Rear Projection-Desktop — The projector
Front Projection-Ceiling Mount — The
Rear Projection-Ceiling Mount — The
YPE —Manually select the signal type
T