4.3 FACEPLATE INTERFACE
USER-PROGRAMMABLE LEDS
DEFAULT LABELS FOR LED PANEL 2:
The default labels are intended to represent:
•
GROUP 1...6: The illuminated GROUP is the active settings group.
•
SYNCHROCHECK NO1(4) IN-SYNCH: Voltages have satisfied the synchrocheck element.
The relay is shipped with the default label for the LED panel 2. The LEDs, however, are not pre-programmed. To match the
4
pre-printed label, the LED settings must be entered as shown in the User-programmable LEDs section of chapter 5. The
LEDs are fully user-programmable. The default labels can be replaced by user-printed labels for both panels as explained
in the following section.
a) ENHANCED FACEPLATE
The following procedure requires these pre-requisites:
•
EnerVista UR Setup software is installed and operational
•
The G30 settings have been saved to a settings file
•
The G30 front panel label cutout sheet (GE Multilin part number 1006-0047) has been downloaded from
http://www.gedigitalenergy.com/products/support/ur/URLEDenhanced.doc
•
Small-bladed knife
To create custom LED labels for the enhanced front panel display:
1.
Start the EnerVista UR Setup software.
4-18
Figure 4–20: LED PANELS 2 AND 3 (INDEX TEMPLATE)
Figure 4–21: LED PANEL 2 (DEFAULT LABELS)
G30 Generator Protection System
4 HUMAN INTERFACES
USER-PROGRAMMABLE LEDS
4.3.3 CUSTOM LABELING OF LEDS
and printed
842782A1.CDR
GE Multilin