Operation; Preparing Recorder For Operation - ABB Fulscope 76J Series Model C Instructions Manual

3.1

PREPARING RECORDER FOR OPERATION

1. Pull pen lifter forward to raise pen off chart, Figure 7.
2. Start chart drive as follows:
a. Electric Chart Drive - Turn power on.
b. Spring-Wound chart drive - Lift clamp in chart hub and remove chart. Wind clock
using key supplied with recorder, then replace chart.
3. Check to see that edge of chart is engaged under retainer tabs.
4. Lift clamp in chart hub and rotate chart until correct time line on chart is aligned with PEN
ARC reference on chart plate.
5. Push clamp down to retain chart on hub at adjusted position.
6. Prepare pen(s) as follows:
a. V-type Pen - Fill each pen with Taylor recorder ink using dropper supplied with ink.
Do not fill pen completely because ink may absorb moisture and spill over.
* NOTE
b. Fiber-Tip Pen - Remove cap from pen tip. Pen will begin to write when it touches
chart.
c. Optional Reservoir Pen - Fill pen by following instructions supplied.
7. Push pen lifter inward to allow pen(s) to contact chart surface.
Recorder is now ready for operation.

OPERATION

When pen is new, a slight oil residue may prevent ink from flowing. Remove
residue by washing pen in an oil dissolving solvent.
76J Pneumatic Fulscope Recorder
3
OPERATION
13