HP 10500 Series Configuration Manual page 194

# Create interface Tunnel 1.
[SwitchA] interface tunnel 1
# Specify an IPv6 address for interface Tunnel 1.
[SwitchA-Tunnel1] ipv6 address 3001::1:1 64
# Configure the tunnel encapsulation mode as IPv6 over IPv6.
[SwitchA-Tunnel1] tunnel-protocol ipv6-ipv6
# Specify the IP address of VLAN-interface 101 as the source address for interface Tunnel 1.
[SwitchA-Tunnel1] source 2001::11:1
# Specify the IP address of VLAN-interface 101 of Switch B as the destination address for interface
Tunnel 1.
[SwitchA-Tunnel1] destination 2002::22:1
# Apply service loopback group 1 on the tunnel.
[SwitchA-Tunnel1] service-loopback-group 1
[SwitchA-Tunnel1] quit
# Configure a static route destined for the IPv6 network Group 2 through interface Tunnel 1.
[SwitchA] ipv6 route-static 2002:3:: 64 tunnel 1
Configure Switch B:
•
# Enable IPv6.
<SwitchB> system-view
[SwitchB] ipv6
# Specify an IPv6 address for VLAN-interface 100.
[SwitchB] interface vlan-interface 100
[SwitchB-Vlan-interface100] ipv6 address 2002:3::1 64
[SwitchB-Vlan-interface100] quit
# Specify an IPv6 address for VLAN-interface 101, the physical interface of the tunnel.
[SwitchB] interface vlan-interface 101
[SwitchB-Vlan-interface101] ipv6 address 2002::22:1 64
[SwitchB-Vlan-interface101] quit
# Create service loopback group 1 and specify its service type as tunnel.
[SwitchB] service-loopback group 1 type tunnel
# Assign GigabitEthernet 1/0/3 to service loopback group 1, and disable STP, and LLDP on the
interface.
[SwitchB] interface GigabitEthernet 1/0/3
[SwitchB-GigabitEthernet1/0/3] undo stp enable
[SwitchB-GigabitEthernet1/0/3] undo lldp enable
[SwitchB-GigabitEthernet1/0/3] port service-loopback group 1
[SwitchB-GigabitEthernet1/0/3] quit
# Create interface Tunnel 2.
[SwitchB] interface tunnel 2
# Specify an IPv6 address for interface Tunnel 2.
[SwitchB-Tunnel2] ipv6 address 3001::1:2 64
# Configure the tunnel encapsulation mode as IPv6 over IPv6.
[SwitchB-Tunnel2] tunnel-protocol ipv6-ipv6
# Specify the IP address of VLAN-interface 101 as the source address for interface Tunnel 2.
[SwitchB-Tunnel2] source 2002::22:1
185