Table of Contents
Advertisement
Canada, Industry Canada (IC) Notices
This device complies with Industry Canada's licence-exempt RSS standard(s). Operation is subject
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause undesired
operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage
est susceptible d'en compromettre le fonctionnement.
CAN ICES-3(B)/NMB-3(B)
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
The IC ID for this device is 3568A-Z01BDC.
This device and its antenna(s) must not be co-located or operated in conjunction with any other
antenna or transmitter, except tested built-in radios.
Cet appareil et son antenne ne doivent pas être situés ou fonctionner en conjonction avec une
autre antenne ou un autre émetteur, exception faites des radios intégrées qui ont été testées.
The County Code Selection feature is disabled for products marketed in the US/ Canada.
La fonction de sélection de l'indicatif du pays est désactivée pour les produits commercialisés aux
États-Unis et au Canada.
FOR PORTABLE DEVICE (<20cm from body / SAR needed)
The product complies with the Canada portable RF exposure limit set forth for an uncontrolled
environment and is safe for intended operation as described in this manual. RF exposure can be
reduced further if the product can be kept as far as possible from the user body or if it is set to a
lower output power, if such function is available.
This device has been tested for compliance with IC SAR values at a typical operating near the body.
To ensure that RF exposure levels are below the levels tested, use accessories with this equipment
to maintain a minimum separation distance of 1 cm between the body of the user and the device.
These accessories should not contain metallic components. It is possible that the accessories used
close to the body that do not meet these requirements are not consistent with the SAR limits and it
is advisable to avoid using them.
107
Advertisement
Table of Contents
