HP 10500 Series Configuration Manual page 48

Hide thumbs Also See for 10500 Series:

Table of Contents

# Bind Ten-GigabitEthernet 3/0/1 and Ten-GigabitEthernet 3/0/2 to IRF-port 1 and IRF-port 2,

respectively.

[Sysname] irf-port 1

[Sysname-irf-port1] port group interface ten-gigabitethernet 3/0/1

[Sysname-irf-port1] quit

[Sysname] irf-port 2

[Sysname-irf-port2] port group interface ten-gigabitethernet 3/0/2

[Sysname-irf-port2] quit

# Save the configuration.

[Sysname] save

# Connect Device D to Device A and Device C, as shown in

# Log in to Device D. (Details not shown.)

# Enable IRF mode.

<Sysname> system-view

[Sysname] chassis convert mode irf

The device will switch to IRF mode and reboot. You are recommended to save the current

running configuration and specify the configuration file for the next startup.

Continue? [Y/N]:y

Do you want to convert the content of the next startup configuration file

flash:/startup.cfg to make it available in IRF mode? [Y/N]:y

Please wait...

Saving the converted configuration file to the main board succeeded.

Slot 1:

Saving the converted configuration file succeeded.

Now rebooting, please wait...

Device D reboots to join the IRF fabric. A four-chassis IRF fabric is formed.

Configure LACP MAD or BFD MAD on the IRF fabric, as described in the previous configuration

examples. (Details not shown.)

Figure

17.

Table of Contents

Show Quick Links

Table of Contents