SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damages that are the result of incorrect installation or usage. Always keep the instructions in a safe and accessible location for future reference.
Old hose sets must not be reused. • If the mains power supply cable is damaged, it must be • replaced by the manufacturer, its Authorised Service Centre or similarly qualified persons to avoid an electrical hazard. Before any maintenance operation, deactivate the appliance •...
• You can extend the drain hose to maximum 400 • Do not touch the glass door while a programme cm. Contact the service centre for the other is in operation. The glass can get hot. drain hose and the extension. SERVICE •...
PROGRAMME CHART Maximum load Programme Programme description Maximum spin Temperature range (Type of load and soil level) speed 30'@30° 3 kg A short cycle for synthetic and delicate items with 30°C 800 rpm light soil level or for items to freshen up. Cottons 8 kg White cotton and coloured cotton.
Page 8
Approximate Energy con- Water con- Remaining programme Programmes Load (kg) sumption sumption (li- duration (mi- moisture (%) (kWh) tre) nutes) Cottons 60°C 1,35 Cottons 40°C 0,87 Synthetics 40°C 0,60 Delicates 40°C 0,55 Wool/Handwash 0,45 30°C Standard cotton programmes Standard 60°C cot- 0,96 Standard 60°C cot- 0,73...
Page 9
• The drum turns regularly to prevent the laundry If you set also the Extra Rinse function ( ) the creases. appliance adds two or more rinses. • The door stays locked. You must drain the water The related indicator comes on. to unlock the door.
If you deactivate the acoustic signals, they continue operate when the appliance has a malfunction. BEFORE FIRST USE 1. Connect the mains plug to the mains socket. This removes all possible dirt from the drum and the 2. Open the water tap. tub.
Page 11
LIQUID OR POWDER DETERGENT The display shows the word On. The default position of SETTING A PROGRAMME the flap is A (powder de- tergent). 1. Touch the programme button and set the programme: • The indicator of the button flashes. •...
Page 12
You can cancel or change the set of 1. Touch the button to pause the appliance. the Finish In option before you touch 2. Wait until the indicator goes off. the button . After touching the 3. You can open the door. button you can only cancel the 4.
AUTO-OFF OPTION • After 5 minutes from the end of the washing programme. The AUTO-OFF stand-by option automatically Press the button On/Off to activate the deactivates the appliance to decrease the energy appliance again. consumption. All the indicators and the display go The display shows the end of the last set off when : programme.
CARE AND CLEANING MAINTENANCE WASH WARNING! Refer to Safety chapters. With the low temperature programmes it is possible that some detergent stays in the drum. Make regularly a maintenance wash. To do this: EXTERNAL CLEANING • Remove the laundry from the drum. •...
CLEANING THE INLET HOSE AND THE VALVE FILTER 45° 20° FROST PRECAUTIONS If the appliance is installed in an area where the temperature can be less than 0 °C, remove the remaining water from the inlet hose and the drain pump.
early. If the alarm code appears again, contact WARNING! Deactivate the appliance the Authorised Service Centre. before you do the checks. POSSIBLE FAILURES Problem Possible solution The programme does not • Make sure that the mains plug is connected to the mains socket. start.
Problem Possible solution The appliance makes an • Make sure the levelling of the appliance is correct. Refer to 'Installa- unusual noise. tion instruction'. • Make sure that the packaging and/or the transit bolts are removed. Refer to 'Installation instruction'. •...
Spin Speed Maximum 1400 rpm 1) The appliance works correctly if the water pressure is not lower than 0.05 MPa (0.5 bar). If you cannot connect the water inlet hose to the cold water tap of the primary hydraulic system, connect it to your do- mestic cold water storage system.