Advertisement
3
Configure
Add Location
After signing in, you need to add the location of the
SMRT Logic.
1. Click + Add a Location.
2. Fill out the Name and Description fields.
3. On the Google Maps map, enter desired address
into the Address field. Click Search map.
Enter address here
4. Click Submit.
Adding the SMRT Logic
Now you have to add
the SMRT Logic to your
SMRTscape account.
1.
Click [Add].
2.
Type in the
Smart ID found
on the bottom of
the unit.
3.
Enter the
Security Key also
found on bottom.
Click Submit.
4.
The SMRT Logic should be added to the system.
Add Controller to the SMRT Logic
Multiple controllers can be added.
Controllers must be added one at a time.
Click +Add a controller.
1.
2.
Select the Controller from the dropdown menu.
3.
Enter the name, description, Climate Logic ID or
Smart ID, PIN (see PIN Setup below).
PIN Setup
The SMRT Logic PIN must match the PIN entered in
the EVOLUTION controller or Climate Logic device for
the system to operate.
Use the included SMRT Logic Information Card to
record the necessary info from the SMRT Logic device
and the irrigation controller for easy entry into the
SMRTscape.com website.
To setup a new PIN or view an existing one, at the
irrigation controller, follow these steps:
For an EVOLUTION controller:
Go to ADVANCED►ADD/REMOVE
DEVICE►REMOTE.
For a Climate Logic controller:
Go to MENU►REMOTE.
For a Climate Logic Mini Receiver (CL-MR):
1. Put the Mini Receiver into Learn Mode by
holding down the only button for more than 8
seconds.
2. Enter the PIN under the corresponding
SMRTscape controller page.
3. Manually turn a station ON or OFF.
4. The Mini Receiver will learn the new PIN
and exit Learn Mode.
The PIN can be set in the CL-MR using a
remote transmitter (CL-R1). See the CL-MR
manual for instructions.
Advertisement
