Mechanical installation
3.3 Installing the Braking Module
5. Insert the Braking Module where the cover used to be and secure it using the 3 screws
6. Secure the connecting cable to the DC link with 2 screws (Braking Module connection)
Carry out the subsequent steps in reverse order from steps 1 – 3.
An opening above the connections for the braking resistor (R1, R2) is provided in the cover
for connecting the cable to the braking resistor.
CAUTION
You must observe the tightening torques. Information on this can be found in the table in
the "Mechanical installation" section
22
(from step 4).
and 2 nuts (DC link connection).
Braking Module / braking resistor
Operating Instructions, 03/2012, A5E00331454A