Assembly - Electrolux 140603 Owner's Manual

BEFORE YOU START TO ASSEMBLE THE GRASS CATCHER
Some tractor models may need minor modifi cations before you can mount the grass catcher to the tractor. Look care-
fully at the mower deck on your tractor and compare the deck mandrel to the illustrations below. If your mower deck
mandrel looks like STYLE "A", your tractor is ready - proceed with the grass catcher assembly. If your mower deck
mandrel looks like STYLE "B", go to the PREPARATION section in this manual.
DECK MANDREL
PARTS IDENTIFICATION
GRASS
CATCHER
CONTAINERS
NOTE: When right hand (R.H.) and left hand (L.H.) are mentioned in this manual, it means when you are seated on the
tractor, in the operator's position.
THESE ARE THE TOOLS YOU WILL NEED TO
ASSEMBLE YOUR GRASS CATCHER:
CAUTION: BEFORE ASSEMBLING GRASS CATCHER TO TRACTOR:
• Depress clutch/brake pedal fully and set parking brake.
• Place gearshift/motion control lever in neutral (N) position.
• Place attachment clutch in "DISENGAGED" position.
• Turn ignition key "OFF" and remove key.
• Make sure the blade and all moving parts have completely stopped.
• Disconnect spark plug wire from spark plug and place wire where it cannot come in contact
with plug.

ASSEMBLY

STYLE "A"
UPPER CHUTE
COVER
LOWER CHUTE
(1) 3/8" Wrench
(1) 1/2" Wrench
(2) 9/16" Wrenches
(1) 1/2" Socket
(1) 9/16" Deep well Socket
6
DECK MANDREL
STYLE "B"
DUMP
BAG
INDICATOR
CHUTE LATCH
LOWER CHUTE
ATTACHING
WING NUT
(1) Drive Ratchet
(1) 3" or longer Extension
(1) Short Handle
Phillips Screwdriver