Sealey FDT3 Instructions

Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructions
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS AND
CAUTIONS. USE THIS PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY
CAUSE DAMAGE AND/OR PERSONAL INJURY, AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.

1. SAFETY INSTRUCTIONS

3 Maintain the trestle in good condition. Replace or repair damaged parts. Use recommended parts only. Unauthorised parts may
be dangerous and will invalidate the warranty.
3 Keep the trestle clean for best and safest performance and check moving parts alignment regularly.
3 Ensure the workpiece is correctly held or secured before commencing work.
3 Maintain correct balance and footing. Ensure the floor is not slippery and wear non slip shoes.
7 DO NOT use the trestle for any purpose other than for which it is designed.
7 DO NOT operate the trestle if any parts are missing as this may cause failure and/or possible personal injury.
7 DO NOT use it as standing platform. The trestle is for supporting items only.
3 When not in use store in a safe, dry, child proof area and ensure it will not topple over.
2. CONTENTS & SPECIFICATION
Contents:
Uprights . . . . . . . . . . . . . . . . . . . .x2
Platform bar . . . . . . . . . . . . . . . . .x1
Upright supports . . . . . . . . . . . . . .x2
Upright support strut . . . . . . . . . . .x1
Legs . . . . . . . . . . . . . . . . . . . . . . .x4
horizontal struts . . . . . . . . . . . . . . .x2
Upright
supports
x2
3. ASSEMBLY INSTRUCTIONS
Unpack the product and check contents against the list above. Should there be any damaged or missing parts contact your supplier
immediately. When all is satisfactory, assemble the trestle as follows. Please refer each part of the assembly to the relevant diagram figure.
3.1.
Bolt the upright support strut x1 to the upright support x2 using the 2 x12mm long bolts and 2x locking studs (fig. 2.) Ensure that
both of the locking studs (fig. 3.) face in the same direction.
FIG. 3.
INSTRUCTIONS FOR:
Model No:
Specification:
Min working height:
Max working height: . . . . . . . . . . .1310mm
Capacity . . . . . . . . . . . . . . . . . . . .100kg
Uprights
x2
Platform
bar x1
Upright support strut
strut x1
Legs x4
Horizontal
struts x2
F D T
OLD OWN
FDT3
. . . . . . . . . . .810mm
FIG. 2.
T
ELESCOPIC RESTLE
FDT3 - 1 - 260204