Safety Information; Future Use; Service And Repairs - DeWalt DCT100 User Manual

Safety Information


WARNING:
• When installing the unit, always be
sure it is securely mounted.
-
If using an s-hook to suspend from
mounting hook, use s-hook with
spring loaded safety latches.
- if mounting unit to the tripod, check
that the legs are firmly set and that
the tripod is wobble free.
• Pull by the plug rather than the cord
when disconnecting. This will reduce
the risk of damage to the electric plug
and cord.
Make sure that the power and
•
ethernet cords are positioned so
that they will not be tripped over,
or otherwise subjected to damage
or stress.
Grounded Outlet
The power cable must be plugged into an
•
appropriate outlet that is nearby, properly
installed, and grounded in accordance with
all local codes and ordinances.The unit is for
use on a nominal 120V circuit and should be
connected to a grounded outlet. A temporary
adaptor, always being held in place by a screw,
may be used to connect this plug to a 2-pole
outlet if a properly grounded outlet is not
available. The adaptor should be used only until
a properly grounded outlet can be installed by a
qualified electrician. The green colored rigid ear,
lug, and the like, extending from the adaptor
must be connected to a permanent ground such
as a properly grounded outlet box cover.
An extension cord must have adequate
•
wire size (AWG or American Wire Gauge)
for safety. The smaller the gauge number of
the wire, the greater the capacity of the cable.
For example, a 16 gauge wire has more capacity
than an 18 gauge wire. An undersized cord will
cause a drop in line voltage resulting in loss of
power and overheating. When using more than
one extension to make up the total length, be
sure each individual extension contains at least
Ungrounded Outlet with Adaptor
the minimum wire size. The following table
shows the correct size to use depending on
cord length and nameplate ampere rating. If in
doubt, use the next heavier gauge. The lower the
gauge number, the heavier the cord. A proper
extension cord will be marked with the suffix
letter 'W' and with a tag stating 'Suitable for Use
with Outdoor Appliances.
Minimum gauge for Cord sets
Volts Total length of Cord in Ft. (m)
120 V 25 (7.6) 50 (15.2) 100 (30.5) 150 (45.7)
240 V 50 (15.2) 100 (30.5) 200 (61.0) 300 (91.4)
Ampere
Rating
More not
American Wire gauge
Than More
Than
0 6 18
6 10 18
10 12 16
12 16 14
sAVE ThEsE insTRUCTiOns FOR

FUTURE UsE

Service & Repairs
The unit is not serviceable by the user.

WARNING: To assure product SAFETY
and RELIABILITY, repairs, maintenance
and adjustment should be performed by a
D WALT factory service center or a D
e
authorized service center. Always use
identical replacement parts.
Cleaning
ALWAYS unplug the unit when cleaning.

WARNING: Blow dirt and dust out of all air
vents with clean, dry air at least once a week.
To minimize the risk of eye injury, always
wear ANSI Z87.1 approved eye protection
when performing this.

WARNING: Never use solvents or other
harsh chemicals for cleaning the non-
metallic parts of the product. These
chemicals may weaken the plastic materials
used in these parts. Use a cloth dampened
only with water and mild soap. Never let any
English
16 16 14
16 14 12
16 14 12
12 Not Recommended
WALT
e
5