Switching Camera To Monitor - Bosch MVC-FIPM Installation And Operating Manual

18 en | Operation of IP Matrix using the IntuiKey
4.3

Switching Camera to Monitor

You can switch each of the maximum 32 cameras in the system to each of the maximum ten
monitors. In certain cases, depending on how IP Matrix is programmed, several camera
images can be displayed on one monitor, for example as a quad view.
1.
2.
3.
4.
5.
Switching Monitor Displays
Depending on the decoder's configuration for the monitor, either a single view or quad view
will be displayed. You can switch between single view and quad view.
1.
2.
Selecting Cameras and Monitors in Turn
You can select the available cameras and monitors in turn in accordance with their numerical
sequence, without having to enter the number of each camera or monitor. The sequence
follows the numbering on the IP Matrix > Monitors and IP Matrix > Cameras configuration
pages.
1.
2.
3.
4.
F.01U.082.117 | V4.0 | 2008.12
Press the Mon function key and then press the number of the selected monitor.
If you have typed the wrong number, press the Clr function key and enter the number
again.
Press Enter to confirm the monitor selection.
Enter the number of the camera to be connected and press Enter again to confirm the
camera selection. The camera image is displayed on the monitor.
To switch off a camera connection, enter the number 0 and press Enter. There is now no
camera image displayed on the monitor.
Press the Single View softkey to view the image of the selected camera as a single view.
Press the Quad View softkey to view the image of the selected camera in one quadrant of
the quad view.
Press the Next Monitor softkey to select the next monitor in the system. You will see the
camera image that was last assigned to this monitor.
Press the Previous Monitor softkey to select the previous monitor in the system. You will
see the camera image that was last assigned to this monitor.
Press the Next Camera softkey to select the next camera in the system. The camera
image is switched to the monitor that is currently active.
Press the Previous Camera softkey to select the previous camera in the system. The
camera image is switched to the monitor that is currently active.
Installation and Operating Manual
Available from A1 Security Cameras
www.a1securitycameras.com email: sales@a1securitycameras.com
IP Matrix
Bosch Security Systems