Page 1
Home Network System Smart Motion Light KX-HNL100 Model No. Thank you for purchasing a Panasonic product. This document explains how to install the unit properly. For details about how to use the system, refer to the User’s Guide (page 20).
Table of Contents Introduction Accessory information ......3 Important Information About this system ........4 For your safety ........4 Important safety instructions ....6 For best performance ......6 Other information ........6 Installation Location Wireless communication range ...8 Information about sensor features ..8 Installation location examples .....9 Do not install in these locations ..10 Setup Part names and functions ....12...
R Microsoft, Windows, and Internet Explorer are either registered trademarks or trademarks of Microsoft Corporation in the United States and/or other countries. R All other trademarks identified herein are the property of their respective owners. For assistance, please visit http://shop.panasonic.com/support...
There is a risk of swallowing. In the wireless communication error or event they are swallowed, seek failure. medical advice immediately. R Panasonic will not be held responsible for damage or injury caused by For your safety improper connection, installation, or usage.
Page 5
Optical radiation cautions authorized service center. Possibly hazardous optical radiation emitted from this product For assistance, please visit http://shop.panasonic.com/support...
Hub location/avoiding noise malfunctions, or damage to the The hub and other compatible infrared sensor.) Panasonic devices use radio waves to R Operating the product near electrical communicate with each other. appliances may cause interference. R For maximum coverage and...
Page 7
Also do not spray the product with insecticide, glass cleaner, or hair spray. This may cause a change in color or quality of the product. R Do not apply running water to the product. Notice For assistance, please visit http://shop.panasonic.com/support...
We do not PLACE HOLDER PLACE HOLDER recommend use of the unit’s motion sensor features in these situations. R Panasonic takes no responsibility for any injury or damage caused by the use of this unit. Vertical detection range Approx. 58°...
R Areas where hydrogen sulfide, Visitors pass in front of the unit from side ammonia, dust, or toxic gases are to side. Cars in the street are less likely present to cause false detections. For assistance, please visit http://shop.panasonic.com/support...
You can use the LED to confirm the unit’s status. Indicator Status No power, no motion detected, or unit is disabled Motion detected Blinking slowly Registration mode Blinking Communication error, or the unit is out of range of the For assistance, please visit http://shop.panasonic.com/support...
R Press the tabs on the top and bottom of the unit as shown, and then remove the battery cover. PLACE HOLDER PLACE HOLDER Insert the batteries. R Confirm the polarities ( PLACE HOLDER PLACE HOLDER For assistance, please visit http://shop.panasonic.com/support...
PLACE HOLDER PLACE HOLDER Note: R To cancel without registering the unit, press M N on the hub and on this unit again. R If registration fails, the hub sounds several short beeps. For assistance, please visit http://shop.panasonic.com/support...
Remove any debris after drilling the pilot hole. Do not drill the pilot hole into the structure behind the siding. Poor example No support behind exterior surface PLACE HOLDER PLACE HOLDER Siding Open space, no support For assistance, please visit http://shop.panasonic.com/support...
Page 14
R Do not install on gypsum board or concrete blocks. Insert the anchor, tighten the screw, then remove the screw to secure the anchor. For assistance, please visit http://shop.panasonic.com/support...
Page 15
PLACE HOLDER PLACE HOLDER Attach the mounting stand to the outdoor wall. R Secure the stand to the wall by tightening 4 screws (A). R Screw distance (B): xx mm (xx inches) PLACE HOLDER PLACE HOLDER For assistance, please visit http://shop.panasonic.com/support...
Page 16
R Tighten the screw ( 1 ) while R Secure the unit by tightening the holding the screw ( 2 ) until the screw (D). unit is secure. PLACE HOLDER PLACE HOLDER PLACE HOLDER PLACE HOLDER For assistance, please visit http://shop.panasonic.com/support...
Page 17
R Attach the safety wire high on the wall so that the unit does not strike anyone in the event the unit detaches from the wall. R Do not hang from the unit or stand. For assistance, please visit http://shop.panasonic.com/support...
– Notification You can configure the system to send a notification to the [Home Network] app when the unit detects motion. For assistance, please visit http://shop.panasonic.com/support...
-20 °C – 50 °C (-4 °F – 122 °F) R IP rating IP55 R Dimensions (height ´ width ´ depth) 95 mm ´ 95 mm ´ 100 mm (3.74 inches ´ 3.74 inches ´ 3.93 inches) R Mass (weight) For assistance, please visit http://shop.panasonic.com/support...
Appendix Customer services Shop Accessories! for all your Panasonic gear Go to http://shop.panasonic.com/support Get everything you need to get the most out of your Panasonic products Accessories & Parts for your Camera, Phone, A/V products, TV, Computers & Networking, Personal Care, Home Appliances, Headphones, Ba eries, Backup Chargers &...
If your product does not work properly because of a defect in materials or workmanship, Panasonic Corporation of North America (referred to as “the warrantor”) will, for the length of the period indicated on the chart below, which starts with the date of original purchase (“warranty period”), at its option either (a) repair your product with new or refurbished parts,...
Page 23
Service Center. If the problem is not handled to your satisfaction, then write to: Consumer Affairs Department Panasonic Corporation of North America 661 Independence Pkwy Chesapeake, VA 23320 PARTS AND SERVICE, WHICH ARE NOT COVERED BY THIS LIMITED WARRANTY, ARE YOUR RESPONSIBILITY.